Check RMA connection log - workgroup scenario

Note iconNote

Restricted Network Channel (RNC) sites that do not have a constant Internet connection are not required to perform this procedure. RNC sites may run an RMA Connection Log report to verify that a manually launched RMA session completed successfully. RNC sites may proceed to the Start manual update - workgroup scenario topic.

After rebooting the server, you must ensure that the maintenance cycle is complete before you can run a manual update. Wait about 5 minutes after rebooting the server and then go to the Connect portal RMA connection log page to check the RMA connection log report.

  1. On the administration workstation, open a web browser and navigate to the Connect portal (https://connect.pearsonvue.com/Connect/#/authenticate/login).

The Connect portal login page appears.

  1. Enter your Username, Password, and Site ID, and select the Log in button. The portal opens to the Site system information page.
  2. Select the RMA connection log - beta menu in the navigation pane. The RMA connection log page opens and automatically runs the RMA connection log report and lists all RMA cycles that have run in the past 48 hours. 

Note iconNote

In this example, both maintenance cycles and manual cycles were run and completed successfully. See the RMA connection log help topic in the Connect portal online help for further details on using the RMA connection log report.

Note iconWarning

You cannot start a manual update until all RMA cycles are complete! Make sure the last RMA cycle is complete before starting a manual update!

What is next?

Start manual update - workgroup

 

Pearson VUE Proprietary and Confidential